Show Dot1Q-Tunnel - Cisco Catalyst 3560X-24P Command Reference Manual

show dot1q-tunnel

show dot1q-tunnel
Use the show dot1q-tunnel user EXEC command to display information about IEEE 802.1Q tunnel
ports.
Note This command is not supported on switches running the LAN base feature set.
Syntax Description interface interface-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(53)SE2
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples These are examples of output from the show dot1q-tunnel command:
Switch> show dot1q-tunnel
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Gi1/0/6
Po2
Switch> show dot1q-tunnel interface gigabitethernet1/0/1
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Catalyst 3750-X and 3560-X Switch Command Reference
2-560
show dot1q-tunnel [interface interface-id] [ | {begin | exclude | include} expression]
(Optional) Specify the interface for which to display IEEE 802.1Q tunneling
information. Valid interfaces include physical ports and port channels.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02