Dot1X Test Timeout - Cisco Catalyst 3560X-24P Command Reference Manual

dot1x test timeout

dot1x test timeout
Use the dot1x test timeout global configuration command on the switch stack or on a standalone switch
to configure the timeout used to wait for EAPOL response from a port being queried for IEEE 802.1x
readiness.
Syntax Description timeout
Defaults The default setting is 10 seconds.
Command Modes
Global configuration
Command History Release
12.2(53)SE2
Usage Guidelines Use this command to configure the timeout used to wait for EAPOL response.
There is not a no form of this command.
Examples
This example shows how to configure the switch to wait 27 seconds for an EAPOL response:
Switch# dot1x test timeout 27
You can verify the timeout configuration status by entering the show run privileged EXEC command.
Related Commands Command
dot1x test eapol-capable
interface-id]
Catalyst 3750-X and 3560-X Switch Command Reference
2-184
dot1x test timeout timeout
Time in seconds to wait for an EAPOL response. The range is from
1 to 65535 seconds.
Modification
This command was introduced.
[interface
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Description
Checks for IEEE 802.1x readiness on devices connected to
all or to specified IEEE 802.1x-capable ports.
OL-21522-02