Debug Ip Dhcp Snooping - Cisco Catalyst 3560X-24P Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug ip dhcp snooping

Use the debug ip dhcp snooping privileged EXEC command to enable debugging of DHCP snooping.
Use the no form of this command to disable debugging.
Syntax Description
mac-address
agent
event
packet
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
The undebug ip dhcp snooping command is the same as the no debug ip dhcp snooping command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
OL-21522-02
debug ip dhcp snooping {mac-address | agent | event | packet}
no debug ip dhcp snooping {mac-address | agent | event | packet}
Display debug messages for a DHCP packet with the specified MAC address.
Display debug messages for DHCP snooping agents.
Display debug messages for DHCP snooping events.
Display debug messages for DHCP snooping.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are
enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug ip dhcp snooping
B-17