Show Sdm Prefer - Cisco Catalyst 3560X-24P Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

show sdm prefer

Use the show sdm prefer privileged EXEC command to display information about the Switch Database
Management (SDM) templates that can be used to maximize system resources for a particular feature,
or use the command without a keyword to display the template in use.
Although visible in the command-line help, the ipe keyword is not supported.
Note
Syntax Description access
default
dual-ipv4-and-ip
v6 {default |
routing | vlan)
routing
vlan
| begin
| exclude
| include
expression
Command Modes
Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines When you change the SDM template by using the sdm prefer global configuration command, you must
reload the switch for the configuration to take effect. If you enter the show sdm prefer command before
you enter the reload privileged EXEC command, the show sdm prefer command shows the template
currently in use and the template that will become active after a reload.
The numbers displayed for each template represent an approximate maximum number for each feature
resource. The actual number might vary, depending on the actual number of other features configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
OL-21522-02
show sdm prefer [access | default | dual-ipv4-and-ipv6 {default | routing | vlan} | routing | vlan]
[ | {begin | exclude | include} expression]
(Optional) Display the template that maximizes system resources for ACLs.
(Optional) Display the template that balances system resources among features.
(Optional) Display the dual templates that support both IPv4 and IPv6.
• default—Display the default dual template configuration.
• routing—Display the routing dual template configuration.
Note This keyword is not supported on switches running the LAN base feature set.
vlan—Display the VLAN dual template configuration.
•
(Optional) Display the template that maximizes system resources for routing. This
keyword is not supported on switches running the LAN base feature set.
(Optional) Display the template that maximizes system resources for Layer 2
VLANs.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
show sdm prefer
2-743