Logging Event - Cisco Catalyst 3560X-24P Command Reference Manual

logging event

logging event
Use the logging event interface configuration command to enable notification of interface link status
changes. Use the no form of this command to disable notification.
Syntax Description
bundle-status
link-status
power-inline status
spanning-tree
status
trunk-status
Defaults Event logging is disabled.
Command Modes Interface configuration
Command History Release
12.2(53)SE2
Examples This example shows how to enable spanning-tree logging:
Switch(config-if)# logging event spanning-tree
Catalyst 3750-X and 3560-X Switch Command Reference
2-330
logging event {bundle-status | link-status | spanning-tree | status | trunk status}
no logging event {bundle-status | link-status | spanning-tree | status | trunk status}
Enable notification of BUNDLE and UNBUNDLE messages.
Enable notification of interface data link status changes.
See the
Enable notification of spanning-tree events.
Enable notification of spanning-tree state change messages.
Enable notification of trunk-status messages.
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
logging event power-inline-status command.
OL-21522-02