Debug Fastethernet - Cisco Catalyst 3560X-24P Command Reference Manual

debug fastethernet

debug fastethernet
Use the debug fastethernet privileged EXEC command to enable debugging of the Ethernet
management port. Use the no form of this command to disable debugging.
Syntax Description
af
events
packets
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
The undebug fastethernet {af | events | packets} command is the same as the no debug fastethernet
{af | events | packets} command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
show controllers
ethernet-controller
fastethernet
Catalyst 3750-X and 3560-X Switch Command Reference
B-14
debug fastethernet {af | events | packets}
no debug fastethernet {af | events | packets}
Display Ethernet management port software-address-filter debug messages.
Display Ethernet management port event debug messages.
Display Ethernet management port packet debug messages.
Modification
This command was introduced.
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
Description
Displays information about the types of debugging that are enabled.
Displays information about the Ethernet management port.
OL-21522-02