16.12 Certificates And Approvals - Endress+Hauser Proline Prosonic Flow I 400 Operating Instructions Manual

Technical data
CE mark
UKCA marking
RCM marking
Ex-approval
Modbus RS485 certification
Radio approval
External standards and
guidelines
166

16.12 Certificates and approvals

Current certificates and approvals for the product are available at
relevant product page:
1. Select the product using the filters and search field.
2. Open the product page.
3. Select Downloads.
The device meets the legal requirements of the applicable EU Directives. These are listed in
the corresponding EU Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
The device meets the legal requirements of the applicable UK regulations (Statutory
Instruments). These are listed in the UKCA Declaration of Conformity along with the
designated standards. By selecting the order option for UKCA marking, Endress+Hauser
confirms a successful evaluation and testing of the device by affixing the UKCA mark.
Contact address Endress+Hauser UK:
Endress+Hauser Ltd.
Floats Road
Manchester M23 9NF
United Kingdom
www.uk.endress.com
The measuring system meets the EMC requirements of the "Australian Communications
and Media Authority (ACMA)".
The devices are certified for use in hazardous areas and the relevant safety instructions are
provided in the separate "Control Drawing" document. This is referenced on the nameplate.
The measuring device meets all the requirements of the MODBUS RS485 conformity test
and has the "MODBUS RS485 Conformance Test Policy, Version 2.0". The measuring device
has successfully passed all the test procedures carried out.
The measuring device has radio approval.
For detailed information on the radio approval, see the Special Documentation
→  169
• EN 60529
Degrees of protection provided by enclosure (IP code)
• EN 61010-1
Safety requirements for electrical equipment for measurement, control and laboratory
use - general requirements
• IEC/EN 61326-2-3
Emission in accordance with Class A requirements. Electromagnetic compatibility (EMC
requirements).
• ANSI/ISA-61010-1 (82.02.01)
Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory
Use - Part 1 General Requirements
• CAN/CSA-C22.2 No. 61010-1-12
Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory
Use - Part 1 General Requirements
Proline Prosonic Flow I 400 Modbus RS485
www.endress.com on the
Endress+Hauser