Endress+Hauser Proline Prosonic Flow I 400 Operating Instructions Manual page 113

Proline Prosonic Flow I 400 Modbus RS485
Parameter
Assign simulation process variable
Process variable value
Endress+Hauser
or closed-control loops). The simulation can be performed without a real measurement (no
flow of medium through the device).
The parameters displayed depend on:
• The selected device order
• The set operating mode of the pulse/frequency/switch outputs
Navigation
"Diagnostics" menu → Simulation
‣
Simulation
Assign simulation process variable
Process variable value
Current output 1 simulation
Current output value
Frequency output 1 to n simulation
Frequency output 1 to n value
Pulse output simulation 1 to n
Pulse value 1 to n
Switch output simulation 1 to n
Switch state 1 to n
Device alarm simulation
Diagnostic event category
Diagnostic event simulation
Parameter overview with brief description
Prerequisite
–
A process variable is selected in the
Assign simulation process variable
parameter (→  113).
Description
Select a process variable for the
simulation process that is activated.
Enter the simulation value for the
selected process variable.
Commissioning
→  113
→  113
→  114
→  114
→  114
→  114
→  114
→  114
→  114
→  114
→  114
→  114
→  114
Selection / User entry
• Off
• Volume flow
• Mass flow
• Flow velocity
• Sound velocity
• Temperature
• Density
Depends on the process
variable selected
113