Starting And Quitting; Starting; Quitting - Omron F150-2 Operation Manual

Starting and Quitting

2-1

Starting and Quitting

2-1-1

Starting

Note Before connecting components or wiring power supply lines and
grounding wires, be sure to refer to the relevant section in the
Setup Manual.
Use the following procedure to start up the F150.
Note The startup scene and startup mode that appear when power is
turned ON can be set. Use these settings to make daily operation
more efficient once the F150 is ready for actual operation.
2-1-2

Quitting

Save all settings to flash memory before turning OFF the power.
The data in flash memory is loaded each time the F150 is started.
Any changes made will be lost unless they are saved to the flash
memory.
The measurement images and sample images in memory are
also cleared when the power is turned OFF. These images can-
not be saved to flash memory, but they can be backed up on a
computer if required.
8
1
Be sure that the basic F150 components have been con-
nected correctly.
2
Turn ON the power supply on the monitor.
3
Turn ON the power supply on the F150.
A startup message will appear followed by a processing
message. After a short pause, the initial screen will appear.
The following screen will appear the first time power is
turned ON.
→
p. 58
→
Setup Manual p. 7
→
p 48
Section 2-1