Starting/Stopping Recording; Starting Recording; Stopping Recording - Omron EQUO Series User Manual

5.4

Starting/Stopping Recording

5.4.1 Starting Recording

Hold the SET/REC/STOP key (for at least 3 seconds) in RUN mode to start air flow data
recording. The "REC" turns ON when recording starts.
The measured data is recorded and accumulated in the internal memory of the Air Flow
Station unit, and is output in a CSV file to the SD memory card when the SET/REC/STOP
key is pressed.
Important
・If recording starts with recorded data remaining in the internal memory, the remaining
recorded data is lost. To save the data, press the SET/REC/STOP key for less than 3
seconds to output the data to the SD memory card before recording.
・The integrated standard flow rate of the Air Flow Sensor unit is initialized to 0m
recording starts.
Note
・An SD memory card must be placed in the Air Flow Station unit when the
SET/REC/STOP key is pressed for data output during recording, recording is stopped
or the internal memory becomes full. It is not necessarily the case at the point when the
unit starts recording.
Recording to the internal memory can be continued for the following:
The number of connected units is 1 and recording cycle is 1 second:
approx. 5200 data
The number of connected units is 8 and recording cycle is 2 seconds:
approx. 650 data
・Switching to other modes is prohibited during recording. Stop recording when other
mode than RUN mode should be entered.

5.4.2 Stopping Recording

The Air Flow Station unit stops recording if the SET/REC/STOP key is held (for 3 seconds or
longer) during recording (i.e. the "REC" is ON). The data in the internal memory is output to
the SD memory card and "REC" turns OFF.
Important
・A write-enabled SD memory card must have been inserted in the slot when stopping
recording. If a data output attempt fails, an error is output and recording is stopped
without saving the data. To correct this, insert an SD memory card before resuming
recording and press the SET/REC/STOP key to output the data.
・The data accumulated so far is discarded unless it is output before starting recording.
5.Measurement and Recording
5-5
3
when