Starting Up Sysmac Studio - Omron ZW-XC7 User Manual

Starting Up Sysmac Studio

1
Start up Sysmac Studio.
2
Create a new project for the ZW.
From Category, select [Measurement Sensor]
and from Device, select [ZW] to click the [Cre-
ate] button.
Note
If you have a previously created project, click [Open Project] to select the project.
3-7 Saving a project p.94
3
Select the [Specify a sensor] button to spec-
ify the IP address of the Sensor Controller to
be connected.
Click the [Confirm] button to confirm the infor-
mation of the Sensor Controller.
When connection with Sensor Controller is suc-
cessful, Sensor Controller information is dis-
played.
Click [OK] button, the Sensing monitor window
appears.
Edit pane p.82
Note
By default, the Sensor Controller has an IP address of 192.168.250.50
4
Click the [OK] button to establish a connection to the Sensor Controller.
3 Basic Operation p.77
Note
For the basic operations of Sysmac Studio, refer to "Sysmac Studio Version 1 Operation Manual" (W504).
34
Basic Operations for Displaying Measurement Results ZW-7000 User's Manual