Installation And Wiring - Omron DEVICENET SAFETY - SYSTEM CONFIGURATION 07-2009 System Configuration Manual

Basic System Startup Procedure
IMPORTANT Allocate a unique safety network number to each safety network or safety
1-4-2

Installation and Wiring

DeviceNet installation
EtherNet/IP installation
NE1A-series Controller installa-
tion
DeviceNet Safety I/O Terminal
installation
Installation of other devices
Safety functions may be impaired and serious injury may occasionally occur.
Before connecting a device to the network, clear the previous configuration
data.
Safety functions may be impaired and serious injury may occasionally occur.
Before connecting a device to the network, set the appropriate node address
and baud rate.
• Editing Device Parameters
Refer to 3-7 Device Parameters and Properties.
Refer to SECTION 5 Editing Safety Network Controller Parameters.
• Checking the Usage Rate of Network Bandwidth
Refer to 2-2 Allocating Network Bandwidth Usage and Calculating the
Best EPI.
• Calculating the Reaction Time
Refer to 2-3 Calculating and Verifying the Reaction Time.
subnetwork.
In this step, install and wire each device as shown below:
• Install all of the devices and set node addresses and baud rates.
• Connect to I/O devices.
• Wire the power supplies.
• Wire the DeviceNet.
• Wire the USB.
• Wire the EtherNet/IP.
Please refer to the following related manuals for details:
Item
DeviceNet Operation Manual
DeviceNet Safety System Configuration
Manual
DeviceNet Safety Safety Network Controller
Operation Manual
DeviceNet Safety I/O Terminal Operation
Manual
Operation manual for each device
!WARNING
!WARNING
Manual name
Section 1-4
Cat. No.
W267
Z905
Z906
Z904
---
9