Table of Contents
Advertisement
Configuration Lock
3-9
Configuration Lock
3-9-1
Locking the Device Configuration
IMPORTANT Operation of the device must be tested before lock the configuration.
Note
82
Perform user testing after verifying the device parameters. Checking all the
operations of the device using user testing indicates that the device parame-
ters have been verified by the user.
The configuration lock symbol indicates that the user test has completed.
After the user testing, lock the configuration using either of the following meth-
ods. This function is enabled only when the Network Configurator is online.
Also, to lock the configuration, verification of the device must have been com-
pleted already.
1. Select one or more devices, and then select Device - Parameter - Lock
from the menu bar.
2. Select one or more devices, and then click each device and select Param-
eter - Lock.
Next, the password input window for the device will be displayed. Enter the
password of the selected devices and click the OK Button.
When selecting multiple devices and setting the same device password for all
the devices, select the Use this password for all device check box in the fol-
lowing dialog box, and then entering passwords will no longer be necessary
for each device.
After the configuration lock has completed, the safety symbol attached to the
device icon in the virtual network will change to a symbol of a lock, which indi-
cates that the configuration lock has completed.
• After performing a configuration lock for all the devices, make sure
to save the network configuration file.
• The symbol that indicates that the configuration lock has been done
ensures that the device has been tested. This information is saved
in the device itself as well as in the network configuration file.
• Once the configuration lock has been performed, you cannot down-
load the parameters to the device. To change the parameters,
release the configuration lock.
Section 3-9
Advertisement
Chapters
Table of Contents
