Setting The Controller As An Ethernet/Ip Standard Target; Registering I/O Assemblies For Standard Targets - Omron DEVICENET SAFETY - SYSTEM CONFIGURATION 07-2009 System Configuration Manual

Setting the Controller as an EtherNet/IP Standard Target

5-4

Setting the Controller as an EtherNet/IP Standard Target

Note
IMPORTANT When connecting to an OMRON CS/CJ-series EtherNet/IP Communications
5-4-1

Registering I/O Assemblies for Standard Targets

Click the EtherNet/IP Target I/O Tab to display the setting window for the Stan-
dard Target I/O assembly that is required to operate an NE1A-series Control-
ler that supports EtherNet/IP as a standard target. The I/O assembly set here
is displayed in and can be selected from the Connection Setting Window of
Units such as CS/CJ-series EtherNet/IP Units (i.e., standard originators). In
addition, the I/O tags can be used in the Logic Editor.
Set the Standard Target I/O assembly, and then set the communications for
the EtherNet/IP originator.
For details on the setup method when connecting to an OMRON CS/CJ-
series EtherNet/IP Communications Unit, refer to Appendix C Editing Parame-
ters for CS/CJ-series EtherNet/IP Units.
When an NE1A-series Controller that supports EtherNet/IP is not used as a
Standard Target, it is not necessary to make the settings in this window.
Unit, the EtherNet/IP I/O communications will be set in 2-byte units. Make the
Standard Target settings in even numbers of bytes.
Register the I/O assemblies for Standard Targets to be used when NE1A-
series Controllers that support EtherNet/IP function as Standard Targets.
The following information is displayed in this window.
Item
Name The names of the registered I/O assembly (
tags (
Type The I/O type of the I/O assembly and the data types for the I/O
tags are displayed.
Size The sizes of the I/O assembly and I/O tags are displayed.
Display
icon) defined in the assembly are displayed.
Section 5-4
icon) and the I/O
137