Omron DEVICENET SAFETY - SYSTEM CONFIGURATION 07-2009 System Configuration Manual page 52

Applications
Safety functions may be impaired and serious injury may occasionally occur.
Before operating the system, perform user testing to confirm that the configu-
ration data of all the devices is correct and that they are operating correctly.
IMPORTANT
Restarting the System
18
Start the Network Configurator and connect it to the network via the USB
port on the NE1A-series Controller or via DeviceNet or EtherNet/IP.
Refer to 3-3 Connecting to the Network.
24. Reading the Network Configuration File
Read the saved network configuration file with verified parameters.
Refer to 3-5-3 Reading a Network Configuration File.
25. Configuration Lock
Lock the configuration of all the devices to indicate that they have been ver-
ified as well as to prevent parameters from being mistakenly rewritten.
Refer to 3-9-1 Locking the Device Configuration.
26. Saving the Network Configuration File
Save the file of a virtual network with a locked configuration.
Refer to 3-5-2 Saving the Network Configuration File.
27. Exiting the Network Configurator
Exit the Network Configurator.
!WARNING
• After configuring all the devices, user testing must be performed to con-
firm that the configuration data and operation of each device are correct.
User testing is performed to verify the safety signature for each device.
• The configuration must be locked after user testing has been completed.
28. Running the System
Run the system.
Section 2-1