Omron DEVICENET SAFETY - SYSTEM CONFIGURATION 07-2009 System Configuration Manual page 47

Applications
Configuration
IMPORTANT
User Testing
8. Starting the Network Configurator and Connecting to the Network
Start the Network Configurator and connect it to the network via the USB
port on the NE1A-series Controller or via DeviceNet or EtherNet/IP.
Refer to 3-3 Connecting to the Network.
9. Reading the Network Configuration File
Read the saved network configuration file with the completed design.
Refer to 3-5-3 Reading a Network Configuration File.
10. Resetting a Device
When changing the configuration because of user testing results or when
downloading the parameters again, it is necessary to clear the previous
configuration before downloading the new parameters. Reset the device by
setting the reset type to Return to the out-of-box configuration, and then
emulate cycling power.
Refer to 3-10-2 Resetting Devices.
11. Downloading Device Parameters
Download the parameters to all the devices.
Refer to 3-7-3 Downloading Device Parameters.
12. Confirming the Downloaded Device Parameters and Safety Signa-
tures
Verify the parameters for all the devices and check if the device parameters
and program that the user input have been correctly downloaded and
saved in the devices.
Refer to 3-8 Parameter Verification.
13. Saving the Network Configuration File
Save the network configuration file in which parameter verification of all the
devices has been completed.
Refer to 3-5-2 Saving the Network Configuration File.
14. Exiting the Network Configurator
Exit the Network Configurator.
• After downloading the device parameters, verify the parameters to con-
firm that the parameters and the safety signature saved in the devices are
correct.
• When selecting Open Only in the Open Type setting for the safety con-
nection, check that the Safety Master and Safety Slave are correctly con-
figured.
15. User Testing
The user himself must verify device parameters and operation to confirm
that safety system requirement specifications are met.
16. Starting the Network Configurator and Connecting to the Network
Start the Network Configurator and connect it to the network via the USB
port on the NE1A-series Controller or via DeviceNet or EtherNet/IP. Refer
to 3-3 Connecting to the Network.
17. Reading the Network Configuration File
Read the saved network configuration file with parameters that are already
verified.
Section 2-1
13