Table of Contents
Advertisement
Programming
Note
Function Block I/O Information
Editing Function Block Parameters
Note
4. Select the name of the jump source and click the OK Button.
The jump address will be displayed as follows:
Double-click a jump address to change the display to the corresponding jump
address.
The input and output descriptions for a function block are displayed when the
mouse cursor is placed on the corresponding I/O point on the screen.
To edit the parameters of a function block, use any of the following methods to
display the Parameter Edit Window.
1. Double-click the function block.
2. Select the function block and then select Edit - Properties from the menu
bar.
3. Right-click the function block and the select Edit from the pop-up menu.
4. Select the function block and then click
The parameters that can be edited depend on the function block. For details,
refer to the Safety Network Controller Operation Manual (Z906).
Section 6-3
Property on the toolbar.
175
Advertisement
Chapters
Table of Contents
