Omron DEVICENET SAFETY - SYSTEM CONFIGURATION 07-2009 System Configuration Manual page 126

Editing Parameters
Note
92
Type
Limit SW 1NC/1NO (See note 1.)
Limit SW 1NC
Enable SW 2NO (See note 1.)
Enable SW 4NO (See note 2.)
Other 2NC (See note 1.)
Other 2NO (See note 1.)
Other 1NC/1NO (See note 1.)
Other 1NC
SLC 2 outputs (See note 1.)
SLC 1 output
Other PNP 2 outputs (See note 1.)
Other PNP output
Reset SW
Welding check (EDM input)
Standard SW
Not Use
(1) Can be selected only when the terminal number is an even number.
(2) Can be selected only when the terminal number is an even number and
there are at least four remaining terminals.
5. Click the Next Button. If there are output terminals (e.g., DST1-MD12SSL-
1), the following dialog box will be displayed.
Comments for each output terminal can be edited in this window.
Section 4-1
Description
Specify to use two inputs (NC and NO)
from a limit switch.
Specify to use one input from a limit
switch.
Specify to use two inputs from an enable
switch.
Specify to use four inputs from an enable
switch.
Specify to use input from other 2-NC
devices.
Specify to use input from other 2-NO
devices.
Specify to use input from other NC/NO
devices.
Specify to use other 1-NC devices.
Specify to use two inputs from a light cur-
tain.
Specify to use one input from a light cur-
tain.
Specify to use two inputs from other
semiconductors.
Specify to use one input from other semi-
conductors.
Specify to use inputs from a reset switch.
Specify to use as feedback signal to
EDM.
Specify to use inputs from a switch for
non-safety applications.
Specify to not use the input.