Table of Contents
Advertisement
Programming
Setting Output Points
Setting Comments
Click the Set Output Point Tab and set whether or not to use the different out-
put point functions for function blocks.
Click the Comment Tab to enter names for the function block or I/O signals.
The names of I/O signals are not displayed in the window, but the name of the
function block is displayed under the function block in the window. The user
can select to display or hide all the names entered in this window when the
program is printed.
Note
With Network Configurator 1.6@ or lower, the number of inputs cannot be
deleted if a connection is made as shown in the following figure (i.e., if a con-
nection is made at the bottom of the inputs and some inputs are not con-
nected.) WIth Ver. 2.0@ or higher, however, the number of inputs can be
deleted up to the number of connections made.
Section 6-3
177
Advertisement
Chapters
Table of Contents
