Table of Contents
Advertisement
Parameter Verification
3-8
Parameter Verification
3-8-1
Device Parameter Verification
78
After downloading the parameters to a device, the user must perform parame-
ter verification to check whether the parameters entered by the user were cor-
rectly downloaded to the device. The user must perform this verification for
safety devices.
Verify the parameters using any of the following methods after downloading
the parameters to devices. This function is enabled only when the Network
Configurator is online.
With Network Configurator Ver. 2.0@ or higher, multiple devices can be
selected and verified all at once.
1. Select a device, and then select Device - Parameter - Verify from the
menu bar.
2. Select a device, and then click the Verify Parameter Button on the toolbar.
3. Select a device, and then right-click the device and select Parameter -
Verify.
The device parameters will be uploaded.
First, the Network Configurator itself checks if the uploaded parameters are
different from the parameters in the virtual network. If there are no differences,
the following dialog box will be displayed.
If you click the OK Button, the uploaded parameters will be displayed.
Section 3-8
Advertisement
Chapters
Table of Contents
