Configuration Example - Omron E3FS Series Manual

Connects to the B1 Module of an F3SX Safety Controller to create a Type 2 Safety Sensor.
Conveniently located LED indicators are easier to read.
• Operating status can be verified from LED indicators on the Sensor.
Receiver
Light received: Green indicator lit
Light interrupted: Red indicator lit

Configuration Example

Emergency Stop Switch
A22E-M-@
Reset Switch
A16
External alarm indicator
Programmable Controller
CJ1M Series
4
Safety
Conforms to IEC, EN, and other international safety standards for worry-free
use in machinery and equipment headed for Europe.
Applicable Standards ---------------------------------------------------------------------------
International standards: IEC61496-1 (type 2 ESPE)
European standards:
Easy to read
Emitter
Emitting: Orange indicator lit
Safety Light Curtain
F3SN-A/-B, F3SH
Single-beam Safety Sensor
E3FS
IEC61496-2 (type 2 AOPD)
EN 61496-1 (type 2 ESPE)
prEN61496-1 (type 2 AOPD)
Pending approval
• Operating status can be checked from LED indicators on the Controller.
ER1, ER2: Various error indications
Note: Refer to the F3SX operation manual for details on
D1: Lit when the first E3FS Sensor receives light
D2: Lit when the second E3FS Sensor receives light
D3: Lit when the third E3FS Sensor receives light
D4: Lit when the fourth E3FS Sensor receives light
An F3SX Dummy Plug (F39-CN4) must be connected to unused F3SX connectors.
When a Dummy Plug is connected, the corresponding LED will be lit.
Single-beam Safety Sensor
E3FS
Safety-Door Switch
D4GS-N, etc.
F3SX-N-L2B1D1R (customized product) shown here
E3FS Single-beam Safety Sensors were added to the
F3SX Series of Safety Controllers to allow one unit to
handle all required inputs and outputs.
SUDDEUTSCHLAND ¨
the lighting pattern of the error indicators.