Push Mode - ICPDAS ET-2268 CR User Manual

Ethernet i/o modules

Table of Contents

ET-2200 Series Ethernet I/O Modules

5.1.2

Push Mode

1. In the Pair-Connection Setting section, choose PUSH and check the box in the Enable Mode

field to enable this mode.

2. In the Remote IP... : Port fields, enter the IP address and the TCP Port of the remote ET-2260#2

module

3. In the IO Count field, enter the mapped quantity for DI and DO.

For example, the PUSH Mode (Local DI to Remote DO) configuration:

Enter "2" in the IO Count field and "0" in both the Local/Remote IO Address fields. This

means

DI0

and DI1 of ET-2260#1 module correspond to

4. In the Local IO Address field, select "1x: Discrete Input.." and enter the starting DI address.

In the Remote IO Address field, select "0x: Coil Output..." and enter the starting DO address.

5. Choose the Modbus protocol (e.g., TCPv4) from the Network Protocol drop-down menu.

6. Click the "Submit..." button to complete the configuration.

DO0

and DO1 of ET-2260#2 module.

-117 -

Table of Contents