Restore Factory Defaults/Firmware Update - ICPDAS ET-2268 CR User Manual

ET-2200 Series Ethernet I/O Modules
Restore Factory Defaults/Firmware
4.3.3
Note: This setup page may be different for some modules, but the functions are the same.
 Restore all options to their factory default states
To reset all parameters to their original factory default settings, use the following procedure:
Step 1: Click the "Restore Defaults" button to factory reset the module.
Step 2: Click the "OK" button in the message dialog box.
Step 3: Check whether the module has been reset to the original factory default settings for use
with the eSearch Utility. Refer to
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
Section 3.3 "Configuring the Network
Factory Defaults
Update
Settings".
-41 -