Page 1
English Version V1.3 Update Jun.2009 ……………………………………………… What’s in your package? One DIO-48 series card One companion ISA CD (V2.1 or later) One Quick Start Guide (This document) ……………………………………………… Installing Windows Driver Follow these steps: 1. Setup the Windows driver. The driver is location at: CD:\NAPDOS\ISA\DIO\DLL\ http://ftp.icpdas.com/pub/cd/iocard/isa/napdos/isa/dio/dll/...
Page 2
The Windows driver only supports Windows 98/NT/2000 and XP/2003/vista 32-bit versions. 2. Click the button to start the installation. 3. Click the button to install the driver into the default folder. 4. Click the button to continue the installation. 5. Select the “NO, I will restart my computer later” and then click the button.
……………………………………………… Installing Hardware on PC Follow these steps: 1. Shut down and power off your computer. 2. Remove the cover from the computer. 3. Select an unused ISA slot. 4. Carefully insert your I/O card into the ISA slot. 5. Replace the PC cover. 6.
Page 4
Select Interrupt Request No devices are conflicting 4. Click “Change Setting” to change Interrupt Request. (Depend on Interrupt Level setting) No devices are conflicting 9. Reboot the PC The detail “add hardware” information. Please refer to CD:\NAPDOS\ISA\Manual\PCI_ISA_PnP_Driver_Installation_in_Win9x_2K_XP.pdf http://ftp.icpdas.com/pub/cd/iocard/isa/napdos/isa/manual/pci_isa_pnp_driver_installation_in_win9x_2k_xp.pdf - 4 -...
……………………………………………… Pin Assignments CH1 and CH2 pin assignment. CN1& CN2 are TTL compatible TTL Range 2.4 V ~5.0 V High(1) (Voltages over 5.0 V will damage the device) None 2.4 V~0.8 V Defined Low(0) Under 0.8 V - 5 -...
Page 6
……………………………………………… Self Test 1. Use the CA-5002(Optional) to connect CN1 to CN2. CA-5002 2. Execute the DIO-48 sample program. Get the file from (Default path): C:\DAQPro\DIO_WinXXX\Demo\ - 6 -...
Page 7
3. Get DIO function test result. Check output value and input value is identical. It’s test successfully. Complete - 7 -...