ICPDAS ET-2268 CR User Manual page 122

Ethernet i/o modules

Table of Contents

ET-2200 Series Ethernet I/O Modules



Step 4-1: Configure the Pair-Connection for the ET-2260#1 (Pull Mode)

1. Click the Pair tab to display the configuration page.

2. In the Pair-Connection Setting section, choose PULL and check the box in the Enable Mode

field to enable this mode.

3. In the Remote IP... : Port fields, enter the IP address and TCP Port of the remote ET-7255

module.

4. In the IO Count field, enter the mapped quantity for DI and DO.

For example, the PULL Mode (Remote DI to Local DO) configuration:

Enter "2" in the "IO Count" field and "0" in both the Local/Remote IO Address fields. This

means

DI0

and DI1 of ET-7255 module correspond to

5. In the Local IO Address field, select "0x: Coil Output..." and enter the starting DO address.

In the Remote IO Address field, select "1x: Discrete Input.." and enter the starting DI address.

6. Choose the Modbus protocol (e.g., TCPv4) from the Network Protocol drop-down menu.

7. Click the "Submit..." button to complete the configuration.

DO0

and DO1 of ET-2260#1 module.

-122 -

Table of Contents