Table of Contents
Advertisement
ET-2200 Series Ethernet I/O Modules
Note: The IPv6 Address and DNS settings are not supported for some models.
The table describes the parameters contained in the "IP Address Configuration" section.
Item
IPv4 Address
Address Type
Static IPv4 Address
Subnet Mask
Default Gateway
MAC Address
IPv6 Address
Link Local Address
SLAAC Address
SLAAC Timeout
(SLAAC Watchdog)
User-defined Address
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
Static IP: If there is no DHCP server installed in your network, you can
configure the network settings manually. Refer to
Configuration"
for more details.
DHCP: Dynamic Host Configuration Protocol (DHCP) is a network
application protocol that automatically assigns an IP address to each
device. Refer to the
Section "Dynamic Configuration"
This parameter is used to assign a specific IP address. Each ET-2200
module connected to the network must have its unique IP address.
This parameter is used to assign the subnet mask for the ET-2200
module. The subnet mask indicates which portion of the IP address is
used to identify the local network or subnet.
This parameter is used to assign the IP Address of the Gateway to be
used by the ET-2200 module. A Gateway (or router) is a device that is
used to connect an individual network to one or more additional
networks.
This parameter is used to set the User-defined MAC address, which
must be in the format FF-FF-FF-FF-FF-FF.
Each IPv6 device connected to the network must have a link-local
address. The address is auto-configured by (P)ET-2200 and is always
effective in the same link layer.
The (P)ET-2200 supports stateless address auto-configuration (SLAAC),
which is automatically configured by the router. The default router is
the link-local address of the router.
This parameter is used to set the Timeout value of SLAAC. If the SLAAC
address is not assigned within the specified time, the system will
reboot and configure the SLAAC address again.
This parameter is used to set the IP address of the module. Each (P)ET-
2200 connected to the network must have a unique IP address.
Description
Section"Manual
for more details.
-37 -
Advertisement
Table of Contents
