Table of Contents
Advertisement
ET-2200 Series Ethernet I/O Modules
5.3
Set Two Modules to Pull Mode (Remote DI to 2-Local DO)
Step 1: Connect the Module to the Network, PC, and Power Supply
Confirm that the ET-2200 series modules are functioning correctly. Refer to
Started"
for more details. Here is the schematic diagram for this example, utilizing the ET-2260 and
ET-7255 modules.
Step 2: Configure the Ethernet Settings
Contact your network administrator to get the correct network configuration information (e.g.,
IP/Mask/Gateway) needed to set up I/O modules. For more instructions, refer to
"Configuring the Network
2
.
1
.
Step 3: Log into the Module's Web Server
1. Choose the ET-2260#1/#2 or ET-7255 module within the eSearch Utility and then click the
"Web" button to open the login webpage.
2. Enter the password in the Login password field (Defaults: "Admin") and click the "Submit"
button to log into the Web Server. (See
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
Settings".
Section 5.1 –
3
.
Step3)
Chapter 3 "Getting
Section 3.3
-121 -
Advertisement
Table of Contents
