Table of Contents
Advertisement
ET-2200 Series Ethernet I/O Modules
The table describes the parameters contained in the "I/O Pair-Connection Settings" section.
Item
Used to enable or disable the Client (Master) function and select
either PULL or PUSH mode.
PULL Mode:
Enable Mode
To read the remote AI (or DI) and write to the local AO (or DO).
PUSH Mode:
To read the local AI (or DI) and write to the remote AO (or DO).
Used to set the IP address or the hostname of the remote module.
Remote IP
Before entering the Host Name, ensure that the correct DNS has been
set on the Network page.
Used to set the TCP port number of the remote device.
Remote Port
The valid range is 0 - 65535.
Used to set the Modbus Net ID of the remote device.
Net ID
The valid range is 1 - 247.
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
Description
DI/DO Module
Defaults
Disable
0
502
1
-61 -
Advertisement
Table of Contents
