Set Two Modules To Push Mode (Local Di To Remote Do) - ICPDAS ET-2268 CR User Manual

ET-2200 Series Ethernet I/O Modules
5.2

Set Two Modules to Push Mode (Local DI to Remote DO)

 Step 1: Connect the Module to the Network, PC, and Power Supply
Confirm that the ET-2200 series modules are functioning correctly. Refer to
Started" for more details. Here is the schematic diagram for this example, utilizing the ET-2260
module.
 Step 2: Configure the Ethernet Settings
Contact your network administrator to get the correct network configuration information (e.g.,
IP/Mask/Gateway) needed to set up I/O modules. For more instructions, refer to
"Configuring the Network
2
.
1
.
 Step 3: Log into the ET-2200 Web Server
1. Choose the ET-2260#1 or ET-2260#2 module within the eSearch Utility and then click the
"Web" button to open the login webpage.
2. Enter the password in the Login password field (Defaults: "Admin") and click the "Submit"
button to log into the Web Server. (See
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
Settings".
Section 5.1 –
Chapter 3 "Getting
3
.
Step3)
Section 3.3
-118 -