Getting Started; Configuring The Operating Mode - ICPDAS ET-2268 CR User Manual

Ethernet i/o modules

Table of Contents

ET-2200 Series Ethernet I/O Modules

3. Getting Started

This chapter provides a basic overview of how to configure and operate your ET-2200 series

module.

3.1

All ET-2200 series modules feature two operating modes, which can be selected by adjusting the

switch on the module. Note that it is necessary to

operating mode.

Init Mode

The Init Mode should be chosen when updating the firmware or conducting

troubleshooting. In this mode, the configurations of the module will be

forced to the default factory settings.

Run Mode

Run Mode is the default operating mode and should be used in most cases.

Note

1. After updating the firmware, be sure to set the switch back to the "Run" position and

reboot the module.

2. If the user cannot log in to the module's web server or forget the password, please refer to

Appendix A

to restore the factory default settings.

reboot the module

after modifying the

-24 -

Table of Contents