Filter; Filter Settings - ICPDAS ET-2268 CR User Manual

ET-2200 Series Ethernet I/O Modules
4.8

Filter

The Filter Settings section on the Filter page allows you to configure the IP Filter list for the ET-
2200 series module, which will be described in more detail below.
4.8.1

Filter Settings

The Filter Settings function is used to query or set the IP Filter List (Available IP) for the ET-2200
series module. Only Clients whose IP address is specified in the list will be able to access the ET-2200
series module. Note that some of the modules do not support the IPv6 setting.
The table describes the parameters contained in the "IP Address Configuration" section.
Item
IP1 ~ IP5
Enable IP Filter
Update Settings
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
Enter the accessible IP address (IPv4 or IPv6). Note that remember to
enter the IP address of the PC used to configure the module.
Check the item to enable the function (Defaults: Disabled).
Click this button to save the changes.
Description
-63 -