General Settings - ICPDAS ET-2268 CR User Manual

ET-2200 Series Ethernet I/O Modules
4.3.2

General Settings

The table describes the parameters contained in the "General Settings" section.
Item
Ethernet Speed
System Timeout
(Network Watchdog)
TCP Timeout (Seconds)
UDP Configuration
Web Auto-logout
Alias Name
HTTP Port
Update Settings
Copyright © 2023 ICP DAS CO., Ltd. All Rights Reserved.
This parameter is used to set the Ethernet speed. The default value is
Auto (Auto = 10/100 Mbps Auto-negotiation).
This parameter is used to configure the system timeout value. If there is
no activity on the network for a specific time, the system will be
rebooted based on the configured system timeout value.
This parameter is used to configure the TCP timeout value. If Modbus
TCP communication is idle for a specific time, the system will cut off the
connection.
This parameter is used to enable or disable the UDP configuration
function.
This parameter is used to configure the automatic logout value. If there
is no activity on the web server for a specific time, the current user
account will automatically be logged out.
This parameter is used to assign an alias name for each ET-2200 module
to assist with easy identification.
This parameter is used to assign specific a HTTP port to the ET-2200
module. The ET-2200 needs to be restarted when the HTTP port is
changed. You need manually type the new HTTP port in the address bar
of the browser. The default is 80. For example, if the HTTP port is set to
81, then enter the "IP address: HTTP port" (10.0.8.123:81).
Click this button to save the changes.
Description
-40 -