Mallinckrodt INOmax DSIR Plus MRI Operation Manual page 122

Cleaning Agent
PDI Super Sani Cloth by PDI
Sani Cloth HB by PDI
Asepti-HB by Ecolab Inc.
Cavicide and CaviWipes by Metrex
Cleaning Water Bottle
If alcohol is used to clean water bottle, make sure alcohol is completely evaporated before
Caution:
placing back onto sample block.
• Alcohol vapors will cause NO
to read low (approximately 0.5 to one ppm).
• This is a transient response and will stop once alcohol vapors dissipate (bottle dries out).
Procedure
• Clean water bottle with a soft cloth dampened in a mild soap and water solution or with isopropyl alcohol (70%).
• Allow water bottle to air dry.
Bioquell Hydrogen Peroxide Sterilant
Bioquell Hydrogen Peroxide Sterilant and hydrogen peroxide vapor generators are regulated by the US
Environmental Protection Agency (EPA) as pesticide chemicals in accordance with Federal Insecticide,
Fungicide, and Rodenticide Act (FIFRA). Use of these products in cleaning/disinfection processes have
not been validated with the INOmax DS
INOmax DS Plus MRI or any ancillary products used with the INOmax DS
IR
6-4
Active Ingredients
n-Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl
ammonium chlorides 0.25%
n-Alkyl (60% C14, 30% C16, 5% C12, 5% C18)
dimethyl benzyl ammonium chlorides 0.25%
Isopropyl alcohol 55%
Inert ingredients 44.50%
n-Alkyl (60% C14, 30% C16, 5% C12, 5% C18)
dimethyl benzyl ammonium chlorides 0.07%
n-Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl
ammonium chlorides 0.07%
Inert ingredients 99.86%
n-Alkyl (60% C14, 30% C16, 5% C12, 5% C18)
dimethyl benzyl ammonium chlorides 0.07%
n-Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl
ammonium chlorides 0.07%
Inert ingredients 99.86%
Diisobutylphenooxyethoxyethyl dimethyl benzyl
ammonium chloride 0.28%
Isopropyl alcohol 17.2%
Inert ingredients 82.52%
sensor to read high (as much as six ppm) and NO sensor
2
Plus MRI. Do not use these products to decontaminate the
IR
Plus MRI.
IR
Part No. 20568 Rev-02
2015-08