Table of Contents
Advertisement
Initial connections
1a
3
2a
Part No. 20568 Rev-02
2015-08
WARNING:
1. Confirm the water bottle and water
separator cartridge are in place
Connect the patient gas sample line with
Nafion to the sample line inlet port on the
1b
front of the INOmax DS
Check cables and hoses for signs of wear and
damage.
2. Insert the injector module cable into the
INOmax DS
module, lining up the red dots on both
ends
3. Connect the injector tubing to the INOmax
DS
IR
WARNING:
Note:
2b
Only use parts/
accessories designated
for use with this system.
Plus MRI
IR
Plus MRI and the injector
IR
2a
.
Plus MRI and the injector module
Be certain all cables and
hoses are positioned to
help prevent damaging or
occluding them.
• It is recommended to disinfect or
sterilize the MR injector module prior
to initial setup.
• To remove this type of connector, the
knurled sleeve
2b
on the connector
must be pulled outward before
removing the connector from the MR
injector module or the front panel.
1a
.
1b
.
3
.
2-3
Advertisement
Table of Contents
