Troubleshooting - Yamaha MONTAGE M6 Operation Manual

Troubleshooting

No sound? Wrong sound? When a problem like this occurs, make sure to check the
troubleshooting section before assuming that the product is faulty.
Many problems can be solved by carrying out
USB flash drive.
If the problem persists, consult your Yamaha dealer.
The touchscreen response is poor
Is the cursor pointing to the precise location you have touched on the touchscreen?
If not, calibrate the touchscreen.
[UTILITY] + [DAW REMOTE] → Calibrate Touch Panel
[UTILITY] → Settings → System → Calibrate Touch Panel
The Ribbon Controller response is poor
Calibrate the ribbon controller.
[UTILITY] → Settings → System → Calibrate Ribbon Controller
No sound
Are all Control sliders set to appropriate levels (other than zero or minimum)?
Are any amplifiers, speakers, or headphones connected to the instrument?
Since this instrument has no built-in speakers, it is necessary to connect amplifiers,
speakers, or headphones to hear any sounds.
Is this instrument as well as any connected devices turned on?
Have you made all the appropriate level settings—including the Master Volume on
this instrument and the volume settings on the connected device?
When a foot controller is connected to the FOOT CONTROLLER jack, try moving the foot
controller.
Is Local Control set to Off?
When Local Control is set to Off, no sound is produced when you play the keyboard.
[UTILITY] → Settings → MIDI I/O → Local Control
Is a blank Part selected?
Initialize All Data, after backing up your data to a
566
om02screenparameters0480