Yamaha MONTAGE M6 Operation Manual page 98

(1) Tone generator block
(recognizing data over MIDI Channel 3)
(2) Keyboard
(output via MIDI Channel 1)
Local Control ＝ off
(3)
(4) Computer (Cubase, etc.)
2
Record the keyboard performance on the DAW.
Using the tone generator block to play back Songs on the DAW
This shows how to use the DAW software as a Multi-timbral sound generator.
It allows you to use the high-quality MIDI sound generator without placing too much load on
your computer's CPU.
Settings on the MONTAGE M
1
Select a Performance.
After selecting a Performance, you may find it helpful to use the Mixing screen from: the
[PERFORMANCE] → Mixing to mix Part 1 to 16.
Also, set Kbd Ctrl Lock On from the [UTILITY] → Effect Switch screen to set Tx/Rx Ch. of
each Part to enable the reception of messages.
The setting on the DAW software
98