Yamaha MONTAGE M6 Operation Manual page 381

Selects the 2nd LFO Wave.
Settings: Triangle, Saw Down, Saw Up, Square, Sine, S/H
NOTE
The amplitude modulation phrase is shifted with Sine.
Extended LFO (2nd LFO Extended LFO)
Switches between the old set of settings (Off: 0–99) and a new set of settings with higher
resolution (On: 0–415) for Speed (2nd LFO Speed).
To maintain compatibility of data created with the old settings, set this parameter to Off.
Settings: Off, On
Speed (2nd LFO Speed)
Sets the speed of LFO Wave (2nd LFO Wave) changes.
Settings: 0–99 (When Extended is set to Off), 0–415 (When Extended is set to On)
Phase (2nd LFO Phase)
Sets the initial phase for when LFO Wave (2nd LFO Wave) is reset.
Settings: 0°, 90°, 180°, 270°
Delay (2nd LFO Delay Time)
Sets the time length for the 2nd LFO effect to fade in after you have released the key and the
delay time set in Delay has elapsed.
Settings: 0–99
Key On Reset (2nd LFO Key On Reset)
Resets the oscillation of the 2nd LFO when a key is pressed.
Settings: Off, On
Pitch Modulation Depth (2nd LFO Pitch Modulation Depth)
This parameter creates a vibrato effect (cyclical changes to the pitch) by using the LFO Wave
(2nd LFO Wave), and lets you specify the depth of pitch modulation by the LFO.
Settings: 0–99
Pitch Modulation Operator Depth Ratio (2nd LFO Pitch Modulation Depth Offset)
Sets the depth of the modulation by LFO signals set in Pitch Modulation Depth (2nd LFO Pitch
Modulation Depth).
Settings: 0–7
Amplitude Modulation Depth (2nd LFO Amplitude Modulation Depth)
381