Yamaha MONTAGE M6 Operation Manual page 229

Changes the Arpeggio selection.
Settings: 1–8
Sw (Part Arpeggio Switch)
Sets the Arpeggio of each Part on or off.
Settings: Off, On
When View is set to Category
Category (Arpeggio Category)
Sub (Arpeggio Sub Category)
Name (Arpeggio Name)
Settings: Refer to the Data List.
When View is set to Number
Bank (Arpeggio Bank)
Number (Arpeggio Number)
Name (Arpeggio Name)
Settings: Refer to the Data List.
When View is set to Range
Name (Arpeggio Name)
Settings: Refer to the Data List.
Velocity Limit (Arpeggio Velocity Limit)
Sets the velocity range (lowest and highest values) for playing back the Arpeggio.
When this is set so that the higher value is first and the lower value is second (for example,
93 to 34), the Arpeggio is played only for velocities of 1 to 34 and 93 to 127.
Settings: 1–127
Note Limit (Arpeggio Note Limit)
Sets the note range (the lowest and the highest notes) for playing back the Arpeggio. When
the first note specified is higher than the second (for example, C5 to C4), the Arpeggio is
played for notes in the ranges of C−2 to C4 and C5 to G8.
Settings: C−2–G8
MS Common (Motion Sequencer Common)
On the MS Common screen, you can set the Motion Sequencer parameters used for the entire
Performance.
229