Yamaha MONTAGE M6 Operation Manual page 571

[PERFORMANCE] → Common selection → [EDIT/
→ Volume
[PERFORMANCE] → Part selection → [EDIT/
Volume
Normal Parts (AWM2)
[PERFORMANCE] → Part selection → [EDIT/
Level/Pan → Level
For Drum Parts
[PERFORMANCE] → Part selection → [EDIT/
For Normal Parts (FM-X)
[PERFORMANCE] → Part selection → [EDIT/
Level
For Normal Parts (AN-X)
[PERFORMANCE] → Part selection → [EDIT/
Out Level
The sound is cut off
Is the entire sound exceeding the maximum polyphony?
AWM2 (preset waveforms): 128 (both stereo and mono)
AWM2 (user or library waveforms): 128 (both stereo and mono)
FM-X: 128
AN-X: 16
Only one note sounds at a time
Check if the tone generation mode is set to Mono.
If you wish to play chords, set this parameter to Poly.
[PERFORMANCE] → Part selection → [EDIT/
Mono/Poly
Wrong pitch
Is Tune set to a value other than 0?
[UTILITY] → Settings → Sound → Tone Generator Tune
] → General/Pitch → Perf Settings
] → General/Pitch → Part Settings →
] → Element selection → Amplitude →
] → Key selection → Level/Pan → Level
] → Operator selection → Level →
] → Oscillator selection → OSC/Tune →
] → General/Pitch → Part Settings →
571