Yamaha MONTAGE M6 Operation Manual page 573

When the Part produces a wrong pitch, is the Controller Destination set to Pitch?
[PERFORMANCE] → Part selection → [EDIT/
Destination
For an AN-X Part, is Voltage Drift set to an excessively large value?
[PERFORMANCE] → Part selection → [EDIT/
No effect is applied
Check the effect settings by using [SHIFT] + [NAVIGATION].
Is the Effect Switch off?
[UTILITY] → Effect Switch
Is Variation Send or Reverb Send set to a value other than 0?
[PERFORMANCE] → Part selection → [EDIT/
[PERFORMANCE] → Part selection → [EDIT/
Is Variation Return or Reverb Return set to a value other than 0?
[PERFORMANCE] → Common selection → [EDIT/
Var Return
[PERFORMANCE] → Common selection → [EDIT/
Rev Return
Is the Insertion Effect on all Elements or all Keys in the Part set to Thru?
[PERFORMANCE] → Part selection → [EDIT/
(For System Effects) Is the effect type selected for each effect set to No Effect?
(For Insertion Effects) Is the effect type selected for each effect set to Thru?
Is the Insertion Switch setting appropriate?
[PERFORMANCE] → Part selection → [EDIT/
Cannot start the Arpeggio
Is the [ARP ON/OFF] button on?
Check the number of Parts for which the Arpeggio switch is turned on.
You can simultaneously play back Arpeggios for up to eight Parts.
Are the Note Limit and Velocity Limit settings for the Arpeggio appropriate?
] → Mod/Control → Control Assign →
] → General/Pitch → AN-X Settings
] → Effect → Routing → Var Send
] → Effect → Routing → Rev Send
] → Effect → Routing →
] → Effect → Routing →
] → Effect → Routing → Connect
] → Effect → Ins A or Ins B
573