Troubleshooting - Yamaha Reface DX Reference Manual

Troubleshooting

If this instrument does not behave as expected—for example, not producing the correct sound or
producing no sound at all—please refer first of all to "Troubleshooting" from your Owner's Manual
(page 46). Many issues can also be resolved by doing a Factory Reset (page 40). If any specific
issue should persist, however, please contact your Yamaha dealer or a service center (see the
back of this booklet).
Issue
The instrument
No sound is pro- stopped producing
duced. sound when a setting
was changed.
Notes started to play
Notes continue to
without end when a
play without end.
setting was changed.
Model(s) Suspected cause
reface DX The carrier level is set to 0.
reface DX All carriers are turned off.
The carrier's Fixed fre-
reface DX
quency value is too low.
Rate 4 for the carrier's EG
reface DX
is too low.
Solution
Press the [LEVEL] button from the FM
section, and confirm whether the carrier
level is set to "0" . If so, increase the car-
rier level.
In Edit mode, confirm whether the carrier
is turned on or off. If the carrier is off, turn
it on and ensure that its level is suffi-
ciently high.
In Edit mode, confirm whether the carrier
mode is set to "Fixed" and the "FREQ"
value is too low. If so, increase the
"FREQ" value.
Raise Rate 4 for the EG.
Alternatively, select a different Voice to
stop the sound.
Manual Development Department
© 2015 Yamaha Corporation
Published 05/2015 PO-A0
reface Reference Manual
11