Yamaha MONTAGE M6 Operation Manual page 292

Settings: Poly (polyphonic aftertouch), Channel (channel aftertouch)
Destination
Sets the parameter for the Destination. Tapping the [+] icon lets you add a new Destination.
Source
Cannot be changed from this screen.
This parameter is fixed to Poly AT.
Element Sw (Element Switch) 1–128
You can set the controller setting for each Element on or off.
This parameter is shown only when the selected Destination is related to Elements.
When the ExElemSw on the General/Pitch - ElementSettings screen is set to On, you can
change the switch number by changing the Display Element.
The actual range of numbers you can use in the switch depends on the value set in the
ElementCount on the General/Pitch - ElementSettings screen.
Settings: Off, On
Display Element
Shown only when ExElemSw on the General/Pitch - ElementSettings screen is set to On.
You can select a different group of eight elements corresponding to ElementSw.
Settings: 1–8, 9–16, ..., 121–128 (up to the Element Count setting)
Curve Type
Sets the change curve of the parameter set to Destination.
The horizontal axis represents the controller value set in Source while the vertical axis
represents the parameter value set in Destination.
Settings: Standard, Sigmoid, Threshold, Bell, Dogleg, FM, AM, M, Discrete Saw, Smooth Saw,
Triangle, Square, Trapezoid, Tilt Sine, Bounce, Resonance, Sequence, Hold,
Harmonic, Steps, User 1–32 (when a User bank is selected), Library 1–8 (when a
Library file is loaded)
292