Yamaha MONTAGE M6 Operation Manual page 286

Sets the delay time for starting the playback of the Motion Sequence when Sync is set to
something other than Off or Lane1.
Settings: 0–32
Lane Fade In (Lane Fade In Time Length)
Sets the time to reach the maximum amplitude for the Motion Sequence when Sync is set to
something other than Off.
Settings: 0–32
Lane Vel Limit (Lane Velocity Limit)
Sets the velocity range (lowest and highest values) for playing back the Motion Sequence of the
selected Lane.
This parameter is available when Lane Motion Sequencer is set to something other than Lane
1.
When the Velocity Limit is set to a range from the highest value to the lowest value, the Motion
Sequence will be played back in two velocity ranges: from the maximum to the highest value,
and from the lowest value to the minimum.
Settings: 1–127
Loop/Length tab
Key On Reset (Lane Key On Reset)
Resets the Motion Sequence playback when you press any key on the keyboard.
This parameter is available when Lane Motion Sequencer is set to Arp or something other than
Lane 1.
This parameter is not available when Trigger is set to On.
Settings: Off, Each-On, 1st-On
Each-On: Each time you play any note, the sequence will be reset and the playback
starts from the beginning.
1st-On: Playback starts from the beginning at the first note you play. If the first note is
held while a second note is played, the sequence is not reset at the second or any
subsequent notes.
Loop (Lane Loop)
Sets the Motion Sequence to loop (repeat) playback or one-shot playback.
This parameter is available when Lane Motion Sequencer is set to something other than Lane
1.
Settings: Off, On
Loop Start
286