Table of Contents
Advertisement
only be played back from two velocity ranges: from the maximum to the highest value, and from
the lowest value to the minimum.
Settings: 1–127
Loop/Length tab
Key On Reset (Lane Key On Reset)
Resets the Motion Sequence playback when you press any key on the keyboard.
This parameter is available when Sync (Lane Sync) is set to something other than Lane 1.
This parameter is not available when Trigger is set to On.
Settings: Off, Each-On, 1st-On
Each-On: The sequence will be reset each time you play any note, and playback
starts from the beginning.
1st-On: The sequence will be reset at the first note, and playback starts from the
beginning. The sequence will not be reset when a second note is played while the first
note is being played.
Loop (Lane Loop)
Sets the Motion Sequence to loop (repeat) playback or one-shot playback.
This parameter is available when Sync (Lane Sync) is set to something other than Lane 1.
Settings: Off, On
Loop Start (Lane Loop Start)
Specifies the starting point for loop playback of the Motion Sequence.
Settings: 1–16 (should be below the Length setting)
Length (Motion Seq Length)
Sets the number of steps in the Motion Sequence.
Settings: 1–16 (should be above the Loop Start setting)
MS Grid (Motion Sequencer Grid)
Sets the length of a step in the Motion Sequence.
Settings: 60, 80, 120, 160, 240, 320, 480
Motion Sequence Edit
Opens the setting screen for the Motion Sequence.
You can create a sequence of up to 16 steps.
236
Advertisement
Chapters
Table of Contents
