Yamaha MONTAGE M6 Operation Manual page 237

Loop Start (Lane Loop Start)
Specifies the starting point for loop playback of the Motion Sequence.
Settings: 1–16 (should be below the Length setting)
Length (Motion Sequence Length)
Sets the Motion Sequence length.
Settings: 1–16 (should be above the Loop Start setting)
MS Grid (Motion Sequencer Grid)
Sets the length of a step in the Motion Sequence.
Settings: 60, 80, 120, 160, 240, 320, 480
Sequence Select (Motion Sequence Select)
Changes the Motion Sequence type selection.
Settings: 1–8
Lane Select
Changes the Lane selection.
Settings: 1–4
Polarity (Motion Sequence Polarity)
Sets the polarity of the Motion Sequence.
Settings: Unipolar, Bipolar
Unipolar: Only positive values are used for the parameter change.
Bipolar: Both positive and negative values are used for the parameter change.
Amplitude (Motion Sequence Amplitude)
237