Yamaha MONTAGE M6 Operation Manual page 225

EQ1 Type (A/D Part 2-band EQ 1 Type)
EQ2 Type (A/D Part 2-band EQ 2 Type)
Selects the desired EQ type.
Settings: Thru, LPF, HPF, Low Shelf, Hi Shelf, Peak/Dip
Thru: Bypasses the equalizer leaving the entire signal unaffected.
LPF: Passes the signals above the cutoff frequency.
HPF: Passes the signals below the cutoff frequency.
Low Shelf: Cuts or boosts the signals below the specified frequency setting.
Hi Shelf: Cuts or boosts the signals above the specified frequency setting.
Peak/Dip: Cuts or boosts the signals at the specified frequency setting.
EQ 1 Freq (A/D Part 2-band EQ 1 Frequency)
EQ 2 Freq (A/D Part 2-band EQ 2 Frequency)
Sets the frequency to be cut or boosted.
This parameter is not available when the EQ Type is set to Thru.
Settings: 63.0Hz–18.0kHz
EQ 1 Gain (A/D Part 2-band EQ 1 Gain)
EQ 2 Gain (A/D Part 2-band EQ 2 Gain)
Sets the signal level of the frequency band set in EQ1 Freq or EQ2 Freq.
This parameter is not available when the EQ Type is set to Thru, LPF, or HPF.
Settings: −12.0dB–+12.0dB
EQ 1 Q (A/D Part 2-band EQ 1 Q)
EQ 2 Q (A/D Part 2-band EQ 2 Q)
Sets the bandwidth for cutting or boosting the volume of the frequencies set with EQ1 Freq or
EQ2 Freq.
This parameter is available only when the EQ Type is set to Peak/Dip.
225