Yamaha MONTAGE M6 Operation Manual page 208

Sets the length of time it takes for the sound to change from the moment you press a key until
when the Cutoff Frequency reaches the value set at Attack Level.
This is specified as an offset value to the Part FEG.
Settings: −64–+63
FEG Decay (FEG Decay Time)
Sets the length of time it takes for the Cutoff Frequency to change from the attack level. You can
control the crispness or the decay speed of the sound.
This is specified as an offset value to the Part FEG.
Settings: −64–+63
FEG Rel (FEG Release Time)
Sets the length of time it takes for the Cutoff Frequency to fall to the Release level when you
release the key.
This is specified as an offset value to the Part FEG.
Settings: −64–+63
Cutoff (Cutoff Frequency)
Changes the sound by setting the cutoff frequency of the filter.
When the Low Pass Filter is selected, you can make the sound brighter by setting this to a
larger value, and darker by setting it to a smaller value.
This is specified as an offset value to the filter cutoff frequency for the Part.
Settings: −64–+63
Resonance
Adds special characteristics to the sound by adjusting the signal level near the cutoff frequency.
This is specified as an offset value to the filter resonance for the Part.
Settings: −64–+63
FEG Depth
Sets the depth range of the cutoff frequency change controlled by the FEG.
This is specified as an offset value to the Part FEG Depth.
Settings: −64–+63
Amp EG
On the Amp EG screen, you can set the AEG (Amplitude Envelope Generator) time. By setting
the Amp EG, you can set how the volume changes from the moment you press a key on the
keyboard to when the sound decays.
208