Carry Out Firmware Update - Kaco blueplanet 92.0 TL3 US Manual

9 | Configuration and operation
8. Save your settings.
9.6

Carry out firmware update

NOTE
The DC power supply must be guaranteed during initial start-up.
The sequence of the settings required for initial start-up is preset in the configuration assistant.
CAUTION
Damage to the device from incorrect power supply
The update can fail if the power supply is interrupted during the update process. Parts of the software or of the device it-
self can then be damaged.
1. Never disconnect the DC and AC power supply for or during a firmware update.
2. Do not remove the USB stick during a firmware update.
NOTE
The firmware update can take several minutes. The "Operating" LED flashes during the update
process. The device may restart several times.
Perform Firmware Update
You can upload the current firmware to the devices directly via the web interface. Note the menu entries under
„Firmware Update" See table : Configuration via web user interface [} Page 74]
You can find the firmware on the homepage
Optionally firmware update is possible at the USB socket of the device. Observe the following procedure:
↻ Ensure power supply.
↻ Observe signal elements (LEDs) and states during the process.
↻ Observe the description of the LED states during the process. [See section 9.2} Page 47]
1. Firmware from KACO homepage, upload to a FAT32 formatted USB stick.
2. Insert USB stick into the USB socket of the device.
ð The update process starts with a validated firmware and is signaled by the flashing status LEDs.
3. If the status LED "Operation" and "Feed" LED flash slowly at the same time, remove the USB stick.
4. After successful update, all 3 LEDs light up briefly and device restarts.
5. Check firmware version via the info web interface. [See section 9.3} Page 50]
6. In case of error, you must repeat the update process.
ð Update process successfully completed.
NOTE
Firmware update via Muli-function button
In the previous hardware versions, the firmware update was realized via multifunction buttons. This is no
longer necessary since firmware version 3.3x and is also no longer possible in this new hardware version.
1. Previous manual versions contain this option. You can find them on our homepage in the respective device
folder under Downloads/Archive.
13
It is only possible to configure the grid parameters with DC voltage. The further parameters can also be config-
ured with a present AC voltage.
Page 76
kaco-newenergy.com
KACO blueplanet 92.0 TL3 US KACO blueplanet 110 TL3 US KACO blueplanet 125 TL3 US
Manual
13
under Downloads / Software.