Connecting The Device To The Mains Supply - Kaco blueplanet 92.0 TL3 US Manual

7 | Installation
Interface
Diameter of cable for cable fitting
Torque for cable fitting
RS485 connection type
RS485 terminal cable cross-section
Diameter of cable for cable fitting
Ethernet connection type
7.5

Connecting the device to the mains supply

7.5.1 Preparing the grid connection
↻ A connection cable with 4 cores (4 individual cores or multi-core) up to max. ca-
ble cross-section 0,63 In - is available on the device.
↻ Time required for AC connection: 30 min
↻ Nominal grid voltage matches the VAC nom name plate details.
1. For improved accessibility: Unfasten the AC input plate using the 6 screws [
T_30]
2. Unfasten the cable fitting for AC connection and PE earth (ground) [ W_46].
3. Remove sealing plug.
4. Guide the AC leads through the cable fittings.
5. Strip the insulation from the AC cables.
6. Strip the insulation from individual wires for L1 / L2 / L3 (ABC) and PE (ground)
so that the strand and insulation can be pressed into the cable lug shaft.
. CAUTION! Risk of fire due to chemical corrosion. Cable lugs must be
suitable for the conductor material and copper busbars being used.
7. Press on cable lug.
8. Affix shrink tubing (not included as standard) over the shaft of the ring cable lug
of the AC cable.
9. Fasten the input plate using the 6 screws [ T_30 /
6
When using aluminum cable lugs we recommend using cable lugs with galvanic tin plating or, alternatively, AL/
CU cable lugs with suitable AL/CU washers.
Otherwise, with the electrolytes present (e.g. Condensation water), the aluminum could be destroyed by the
copper bus bars.
Page 26
53.10 In-Ibs ]
KACO blueplanet 92.0 TL3 US KACO blueplanet 110 TL3 US KACO blueplanet 125 TL3 US
Manual
(2x) 0,31 - 0,67 inch
44.25 In-Ibs
Spring-type terminal
23 - 15 AWG
(3x) 0,19 - 0,39 inch
22 In-Ibs
RJ45
4
3
Fig. 24: Removing the AC input
plate
1 Housing base – AC-side
2 Screws for mounting
3 Input plate
4 Cable fitting
6
1
2