Intended Use - Kaco blueplanet 92.0 TL3 US Manual

2 | IMPORTANT SAFETY INSTRUCTIONS
CAUTION
Property damage due to gases that have an abrasive effect on surfaces when they come into contact with
ambient humidity caused by weather conditions!
The housing of the device may be seriously damaged by gases (ammonia, sulfur, etc.) if it comes into contact with ambi-
ent humidity caused by weather conditions.
1. If the device is exposed to gases, it must be installed in a location that is visible.
2. Perform regular visual inspections.
3. Immediately remove any moisture from the housing.
4. Ensure that there is sufficient ventilation at the installation location.
5. Immediately remove dirt, especially on vents.
6. Failure to observe these instructions may result in damage to the device which is not covered by the warranty.
CAUTION
Damage to property due to condensation build-up
If the device is pre-assembled, moisture can get into the internal area via the dust-proof screw connections. The conden-
sate that forms can cause damage to the device during installation and start-up.
ü Keep the device sealed during pre-assembly and don't open the connection area until installation.
1. Seal off any screw fittings using sealing covers.
2. Check the interior space for any condensation water prior to electrical installation and, if necessary, allow it to dry
out sufficiently.
3. Immediately remove any moisture from the housing.
CAUTION
Damage to the device from electrostatic discharge
Components inside the unit can be damaged beyond repair by static discharge.
1. Observe the ESD protective measures.
2. Earth yourself before touching a component by touching a grounded object.
NOTE
There are components within the housing that may only be repaired by our customer service team.
1. Do not attempt to rectify faults that are described here (in the troubleshooting chapter). Get in touch with
our customer service team. Only carry out maintenance activities that are described here.
2. Log each maintenance activity in the "Service" menu item: "Service log" (exception: "User" interface) [See
section 9.4.2} Page 53]
3. The device should be checked for proper operation by a qualified electrician at regular intervals. Always
contact the service team of the system manufacturer if you encounter any issues.
2.2

Intended use

The device is a transformerless PV inverter which converts the direct current of the PV generator into grid-compatible
three-phase alternating current and then feeds the three-phase alternating current into the public power grid.
The device is built using state-of-the-art technology and in accordance with the recognized safety rules. Nevertheless, im-
proper use may cause lethal hazards for the operator or third parties or may result in damage to the device and other
property.
Page 10 KACO blueplanet 92.0 TL3 US KACO blueplanet 110 TL3 US KACO blueplanet 125 TL3 US
Manual